Fully automated culvert moulds

The precast concrete culvert elements, made in these two hydraulically operated moulds, are cast on their side, and turned 90° after demoulding by means of a turning device.

Because the elements were going to be placed at the base of a bored tunnel, the dimensions of the moulds had to cope with very strict technical specifications. The tolerance on the joint dimensions (machined shear key soffits and top recess formers with tongue and groove feature) was +/- 0,75mm.

The width, height, diagonal and radius had to be within a tolerance of +/- 1,5mm.

Special hydraulic and electronic features of the moulds, for making the moulds fool-proof and limiting labour as much as possible:

  • Hydraulic opening and closing of the outside panels
  • Hydraulic shrinking of the inside core
  • Hydraulic securing of the outside panels onto each other
  • Hydraulic securing of the outside panels onto the inside core
  • Hydraulic securing of the shrinkable inside core
  • Hydraulic unit, including tubes, valves, connections and controls
  • Electronic valves and sensors with PLC controls
  • Remote control for all hydraulic movements
Get more out of our website by using cookies

Our website uses cookies to, among other things, give you the best user experience and to track visitor statistics.

I accept all cookies Refuse cookies Set up your preferences